Topic: Roll Cage...Help!
I am in need of a scrutinizing eye, especially since I don't have a cage in yet and we will be racing at PBIR!
I am using a crush bender on 1.50" x .120" ERW tubing (using the fill with sand technique) and I think our bends are coming out well, but there is a very slight dimple on the inner apex of the bend.
See the photo here: http://llracing.weebly.com/cage-photos.html
Will this pass tech assuming everything else is done right?
Also the crush bender is putting small dimples in the tubing, where the tubing contacts the rollers is this ok? The dimples are on a straight portion of tubing, I feel that this will not compromise the cage's structural integrity...but I am not exactly a structural engineer.
Any help is greatly appreciated!